Daikree carel rack controler Three levels of access to display and program the parameters: Drastic reduction in the cost of electrical connections to remote fans. The use of E2V proportional electronic expansion valves in the refrigeration utilities at the point of sale exploits the maximum advantages of the energy saving functions in the compressor rack controller. Operation with floating condensing pressure control to increase the efficiency and the performance of the compressor racks. Available in DIN rail format or for panel installation and with a complete kit of accessories.
|Published (Last):||15 April 2005|
|PDF File Size:||19.1 Mb|
|ePub File Size:||3.81 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page Easy Split Display the controller to make it operative. CAREL then recommends to check that the display does not show any alarm signals see par. Page Functions And Parameters This chapter describes all the functions of the easy, easy compact and Example: In the case of bottle coolers, typically used in supermarkets, easy split.
See Table 1. The protection is based on the times in minutes set for parameters c0; Page 21 only manual defrosts from the keypad or multifunction contact or to set dI to a value which is greater than the maximum set interval.
Page Alarm Parameters A4: 3rd input confi guration easy compact The multifunction input is only available on the easy models with three inputs; is not available on the easy compact models. A0: alarm and fan temperature diff erential This parameter is used to set the functions of the input. The alarm signal can be delayed by setting parameter unit Page 24 14 Product probe again.
Table 4. In easy split models if the light output is Fig. Page Evaporator Fan Management Parameters The evaporator fan control temperature is measured by probe 2, connector Important: these parameters are not available in the compact models. On easy split models there are also the light and second compressor outputs, with or without rotation. Page 30 When set to a positive value values from 0 to 31 are used REQ2 by CAREL for the basic models , if a parameter, including the set point, is modifi ed from the keypad, the value becomes negative.
This allows any modifi cations made the parameters compared to the initial settings to be monitored.
Carel easy User Manual
CAREL | Connected Efficiency
Carel pCO3 series Manuals
pCO3 (scheda I/O)