Makita International Europe Ltd. Page 3 Work area safety Remove any adjusting key or wrench before Keep work area clean and well lit. Cluttered or turning the power tool on. A wrench or a key left dark areas invite accidents.

Author:Salabar Voodookora
Language:English (Spanish)
Published (Last):14 September 2011
PDF File Size:18.40 Mb
ePub File Size:3.37 Mb
Price:Free* [*Free Regsitration Required]

Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Part Number: N In Stock, 11 Available When you use a compressor the air that is compressed inside the tank will condensate and leave water inside the tank. If it is left in the tank too long it can start to rust out the inside of the tank. The Drain Valve should be opened up and let the water drain out. The water will build up if you have a tendency to leave air in your tank for a long period of time.

You should drain your tank after each time it is used to prevent this from happening.


Bedienungsanleitung MAKITA DF330D

Mujar Page 8 Only use accessory or attachment for its stated purpose. It is the fastest way to settle your concern or issue. Watch list is full. Get an immediate offer. Tips for maintaining maximum battery life Switch action Charge the battery cartridge before completely 1.


Makita DF330DWE (2 x 1,3 Ah)


Related Articles